EATON 625/630 SETUP

Before installing an Eaton 625 or 630 scale indicator the unit must first be matched for the load cells/weigh bars that they will be used with. For instance, you can not trade an Eaton 625 scale indicator from load cells to weigh bars without making a few adjustments.

To change the setup of the indicator you will have to either cut out or solder in a few resistors. On newer 625 indicators you will have "dip" switches for the gain resistors which make the setup easier because you do not have to cut out or solder in the gain resistors. All you have to do is flip the switches according to the setup listed below.

Gain resistors Tare resistors

625 Load cell setup cut E & F or turn off 4 & 5 cut none

625 Weigh bar setup cut D,E, & F or turn off 3,4, & 5 cut C

630 load cell setup cut D cut none

630 Weigh bar setup cut C & D cut C

After changing the setup on an indicator the scale will need to be recalibrated because changing the setup will affect the indicators calibration.